CAT 093-1936 SHOE TRACK

CAT 093-1936 are Caterpillar genuine double-tooth medium-duty track shoes, compatible with small excavator/bulldozer chassis with a 190mm pitch and 500mm width. They are designed for low resistance and high maneuverability in frequent turning scenarios, suitable for low-to-medium impact/abrasive conditions such as earthmoving and municipal work, balancing traction and protecting Cat® Parts links.

Core Parameters (Original Nominal, please contact an authorized Cat dealer for precise engineering drawings)

Item Details
Part Model: CAT 093-1936 (0931936) Double Grouser Track Plate

Material and Process: Rolled boron alloy steel + overall heat treatment, hardness HB380–420, hardened layer ≥8mm; CAT yellow primer + wear-resistant coating, salt spray ≥480h

Structure Specifications: Double Grouser, standard hole positions, non-self-cleaning/non-offset; suitable pitch 190mm, track plate width 500mm; comes with 2 sets of track bolts and nuts (recommended 9W-3361/6Y-0846)

Single Weight: Approx. 25.8 kg (56.9 lbs)

Rated Operating Conditions: Moderate impact, non-abrasive environment; check wear/bolt torque every 500 hours

Compatible Models: Mainstream compatible CAT E70B, 307, 312 Small excavators, D4 and D5 series bulldozers; final verification is based on chassis serial number + mounting hole spacing.

Installation Parameters: Bolt specifications 1/2″-20 UNF, installation torque 380–420 N・m, tightened in two crisscrossing stages.

Compatibility and Application Points:

Functional Positioning: Provides ground support and traction, protects track links; the double-tooth design reduces steering resistance compared to a single tooth, making it more suitable for Cat® Parts in construction scenarios requiring frequent steering.

Matching Specifications: Track shoes must be replaced in pairs from the same batch; mixing different materials/thicknesses is strictly prohibited; bolts should be tightened in two crisscrossing stages at 380–420 N・m, and the torque should be checked again after the machine is warmed up to prevent loosening.

Replacement Standards: Tooth height wear > 40%, track shoe cracks, hole deformation / When stripped teeth or hardened layers fall off, replace immediately; do not weld to repair cracked track plates.

Installation and Maintenance Procedure: Stop the machine on a level, hard surface, prop up the machine body, loosen the track tension cylinder, and remove the old track plates.

Clean the mounting surfaces of the track links and the bolt holes of the new plates, removing rust and oil.

Tighten the track in two crisscrossing stages with a torque wrench (initially 70% torque, final 100%).

Restore track tension, drive unloaded for 10 minutes, and then recheck the torque.

Maintenance Cycle: 500 hours under standard operating conditions; 300 hours under high dust/humid conditions. Inspect tooth surface wear, track plate cracks, and bolt anti-loosening marks.